KOASON 10.25inch Digital LCD Dashboard Cluster For Volkswagen TIGUAN 2009-2017

10.25inch Digital LCD Dashboard Cluster For Volkswagen Tiguan 2009-2017

For Volkswagen Tiguan 2009-2017

Product Introduction

1: Easy installation—only requires disassembling the instrument panel, no drilling, no wire cutting, no flashing, and no damage to the original setup. No need for firmware matching or modifying any original vehicle data. Safe and reliable.

2: Linux system, 12 years of expertise in Volkswagen vehicle solutions, optimized through hundreds of iterations, boots in 3 seconds. Never lags. Stable and dependable.

3: 10.25-inch 1920 * 720 high-definition BOE original display, built-in multiple Volkswagen-Audi UI interfaces, supports original steering wheel controls.

4: Built-in phone screen mirroring, multi-language support, unit settings, driving mode settings, all fault light displays, passive settings and notifications, shows all original vehicle data, supports OTA remote upgrades, and more.

5: Original instrument control panel embedded design—never misses any vehicle fault alerts. Ensures comprehensive driving safety.

6: 1:1 mold replication of vehicle body data. Piano lacquer finish, scratch-resistant UV coating, perfectly matches the vehicle body.

Installation Video Tutorial

Note: Before removing the instrument panel, be sure to first adjust the winter tire warning and speed limit warning to their maximum settings, then disable these two functions in the multifunction speed limit menu. The operation tutorial is as follows:

Note: For some high-end Touareg models with mechanical instrument clusters, there is an additional small circuit board on the back of the small screen. It must be secured to the main board as shown in the diagram below before installing it into the LCD instrument panel. Failure to install this small board may result in inaccurate fuel level readings and trigger fault warnings on the dashboard.

LCD Instrument Cluster Installation Tutorial:

The instrument has two USB cables: one is a limited-upgrade USB port, and the other is a limited-screen-mirroring USB port, both located inside the storage compartment on the lower left side of the steering wheel.

After installing the PQ instrument and filling the tank with fuel, if the needle does not reach the full mark, you need to set the fuel tank capacity:

After filling the tank, drive a few hundred meters, then go to Driving Data → Refillable Amount. Here, you will see the remaining fuel quantity. Enter this value in: Settings → Configuration Calibration → Fuel Tank Capacity.

Once set, the Refillable Amount should display 0, and the fuel gauge will then show a full tank.

Note: In the PQ platform settings, the Physical Light option must remain disabled; otherwise, the turn signals may not display.

If it has been enabled, follow the steps in the video below to resolve the issue.

Vehicle Model: If the car model displayed does not match the actual vehicle, it can be changed.

Go to Settings → Vehicle Selection, choose the correct model, then turn off the engine and lock the car for a few minutes.

Instructions

Installation Guide for PQ Tiguan & Scirocco LCD Instrument Cluster

I. Compatibility

1. This installation video is applicable to PQ Tiguan and Scirocco models.

2. This LCD instrument cluster is compatible with all 2010–2017 PQ Tiguan models, regardless of trim level (high/low) or fuel type (gasoline/diesel). It supports both domestic and international variants.

￮ To verify compatibility, compare the mechanical instrument cluster frame in the installation video. If the shape matches, installation is possible.

II. Important Notes

3. Anti-Static Precautions

• To prevent electrostatic discharge (ESD) damage to the motherboard:

￮ Before handling, discharge static electricity by touching a metal water pipe or washing your

hands.

￮ Always hold the PCB by the edges​—​avoid direct contact with electronic components.

4. Do Not Remove the Original Dashboard Buzzer

• If removed, the system will trigger a "Combination Instrument Fault" error.

5. Small PCB on Some Tiguan Mechanical Clusters

• Certain Tiguan models have a small auxiliary PCB behind the mechanical cluster's screen.

￮ Must be installed as shown in the diagram below, inside the LCD cluster.

￮ If missing, it will cause fuel level inaccuracies and fault warnings.

6. Pre-Removal Settings

• Before uninstalling the original instrument cluster:

a. Set Winter Tire Alert and Speed Limit Alert to their maximum values.

b. Disable both functions in the multifunction speed limit settings.

▶  Shipping terms:

Free shipping to Europe/USA/Canada/Singapore/Korea/Japan via express.
For other areas, there maybe extra shipping cost, please check out to see the shipping cost or contact us for it.
Shipping time: usually takes 3-7 days to reach your address (exceptions for special cases and a few areas)

▶  Warranty & Returns:

We provide one month return/replacement and one year warranty service（For details, please check our Return Policy).